Setting up your Linux (Ubuntu) computer to use My Private Network’s MyTelly service should take just a few minutes by following the steps below. While these instructions are based on a Ubuntu 16.04 Xenial Xerus interface, the principal should be similar to most Linux distributions. Please note that your Linux computer needs to be connected to the Internet and able to browse the web before moving on with the instructions below. You do not need to be connected to our VPN for MyTelly to work, kindly disconnect from the VPN if you have it turned on.

Prefer to setup MyTelly using Terminal? Follow the guide in the link below:
 
Linux Smart DNS MyTelly Setup (Terminal)

Not yet registered? It’s quick and easy, Sign Up now!

Check MyTelly DNS Settings

 
Login to our website, www.my-private-network.co.uk from your computer browser and you should be redirected to the My Subscription page.
 
Select the MyTelly tab on the left hand corner of the screen and click on Setup.
 
Check MyTelly Settings
 
Take note of the DNS server addresses that appears on your screen, you’ll need it during the setup later.


Setup MyTelly on your Linux (Ubuntu)

 
Click on the Wireless or Ethernet icon and choose Edit Connections.
 
Edit Connections
 
Select Wi-Fi if Wireless or Ethernet if Wired and click Edit.
 
Network Connections
 
In the network settings, select IPv4 Settings and change the settings as below:
 
Editing WiFi
 
Method: Automatic (DHCP) addresses only
 
DNS Servers: Enter the DNS server addresses that appeared in Step 1
 
Note: The DNS addresses shown in the images here are just examples. Please follow the ones displayed on your own screen as indicated in Step 1.
 
Click Save.
 
You will need to reconnect your network for the settings to take affect. Alternatively, you can also reboot your computer.
 
To reconnect, select your Wireless/Ethernet icon and click on Enable Networking to disable the network momentarily.
 
Enable Networking 1
 
You will see the following message on your screen which indicates that you’ve disconnected from your network.
 
Disconnected
 
Next, click on your Wireless/Ethernet icon once again and choose Enable Networking to re-enable it again.
 
Enable Networking 2
 
You will see the following message on your screen which indicates that you’ve successfully connected to your network.
 
Connected
 
Now, head back to the MyTelly Settings page.


Register IP Address for MyTelly

 
Scroll down and click on Register This Address. This will register your IP address and also test your DNS setup to indicate whether you have configured the DNS settings correctly.
 
Check MyTelly Settings
 
You will get a Your DNS is configured correctly! Enjoy! message on your screen if your DNS has been set successfully on your system.
 
Confirm MyTelly Settings
 
Note: You will not have to do it again unless your IP address changes. Also, any device on the same network will be able to use the MyTelly service as long as you’ve set our DNS on their device’s settings.
 
Now that you have setup and registered your system, you can go ahead and access any TV content providers that we support!


Any Problems?

 
Unfortunately it doesn’t always go to plan!
 
If you have any problems or can’t get MyTelly to work, please email us at support@my-private-network.co.uk. We’ll get back to you as soon as possible and try to help.